Ericsson 1553-FGC 101 1010 Uen A Uživatelská příručka stáhnout pdf (Strana 143)

Upgrading EQ8096 with Input and Output Option Cards

Figure 9.6 Extracting the Output Card

9.3 Replacing (Upgrading) an Input Card

9.3.1 Preparing the Unit

Before installing an Input Card the EQ8096 should be prepared, as follows:

1. Refer to Chapter 2, Installing the Equipment for slot numbering and assignment

information

2. Ensure the unit is disconnected from the AC or DC mains.

3. Maintain ESD precautions.

9.3.2 Store the Current Unit Configuration

Obtain the current unit configuration by obtaining the ‘config’ file held on the

EQ8096’s Flash memory. To do this, perform the following steps:

1. From DOS or Windows ‘Run’, type ‘ftp <ip_address>’ where ‘ip_address’ is the

normal Control IP address in use on the EQ8096.

2. Enter the username: ‘engineer’

3. Enter the password: ‘96QAM’ (case sensitive)

4. Type ‘get config config.xml’

2/1553-FGC 101 1019 Uen A

9-7

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 195 196

Žádné komentáře

Ericsson 1553-FGC 101 1010 Uen A Uživatelská příručka Strana 143