Ericsson EDN312 Uživatelská příručka Strana 2

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 52
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 1
EDN312, ESN108, EXN104, EPN102
User Guide
EDA 1200
.
ii
4/1553-HSC 901 101/2 Uen B 2009-02-27
Copyright
© Copyright Ericsson AB 2006 - 2009. All rights reserved.
Disclaimer
No part of this document may be reproduced in any form without the written
permission of the copyright owner.
The contents of this document are subject to revision without notice due to
continued progress in methodology, design and manufacturing. Ericsson shall
have no liability for any error or damage of any kind resulting from the use of
this document.
Trademark List
LSA - PROFIL® LSA - PROFIL is a registered trademark of KRONE Inc.
LSA PLUS® LSA PLUS is a registered trademark of KRONE Inc.
CORBA® CORBA is a registered trademark of Object Management Group, Inc.
Broadcom® Broadcom is a registered trademark of Broadcom Corporation
The following information is for FCC compliance of class B devices, valid for EDN312xa - BFB 401 05/D11
R1B:
Changes or modifications not expressly approved by Ericsson for compliance could void the user's authority
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Zobrazit stránku 1
1 2 3 4 5 6 7 ... 51 52

Komentáře k této Příručce

Žádné komentáře